Note: Replace depleted batteries promptly to avoid internal acid leakage, which can permanently corrode the electronic circuit board. Programming the Personal Code (PIN)
Move the safe aside. For concrete floors, use a masonry drill bit to create holes matching the width of the expansion bolts. For wood surfaces, use a standard wood drill bit.
Position the safe in your chosen spot. Open the door and use a pencil to mark the drilling points through the pre-drilled holes onto the wall or floor.
with the door open to ensure it works before locking it again. 3. Using the Xtra Safe ATM Piggy Bank Deposit Coins: Insert coins through the top slot. Xtra Safe Kt 82001 Manual
Dual access through a digital keypad (user-programmed PIN) or manual override keys for emergencies.
: Find the screw-secured battery panel usually located on the bottom or interior rear of the unit.
The safe will beep, and the yellow light will turn off to confirm successful programming. Testing Your New Code Note: Replace depleted batteries promptly to avoid internal
Internal compartment spacious enough for up to 5 standard house keys or multiple access cards. 2. Unboxing and First-Time Opening
: Input your new custom 4-digit password using the front keypad.
With the door still open, test the new code by entering it and pressing 'A'/'B'. If the solenoid clicks, the code is set. 4. Normal Operation To Close and Lock Close the door. Turn the master knob counter-clockwise to lock. Enter your PIN code on the keypad. Press 'A' or 'B' . The green light should turn on. Turn the knob clockwise and pull the door open. 5. What to Do If You Lose Your Code (Manual Override) For wood surfaces, use a standard wood drill bit
Since the official manual is scarce, here is a general guide based on standard procedures for installing and setting up an electronic personal safe like the Xtra Safe Kt 82001. Follow these steps to get your safe operational.
During this period, the keypad will not respond to inputs. You must wait out the timer or use the emergency mechanical override key to open it. 6. Wall or Floor Anchoring Guide
If the red or yellow light flashes, the code was not accepted. Repeat the programming steps. 5. Daily Operation and Locking Security
Typically includes a manual override key for situations where the digital code is lost or batteries fail. Standard Operating Procedures