Narishige Pc10 Manual New Jun 2026

Finding the correct settings requires a methodical approach based on your specific experimental needs. Pipette Type Target Tip Size Heater Setting Weight Stack 1.0 – 2.0 µm Moderate-High Microinjection 0.1 – 0.5 µm Extracellular 5.0 – 10.0 µm Low-Moderate Optimization Rules

Loosen terminal blocks and realign the coil loop so it is equidistant from the glass on all sides. Check for uneven room drafts. The heating coil is warped or oxidized unevenly.

Controls the overall length and "shoulder" shape of the pipette. narishige pc10 manual new

Lena turned to troubleshooting and found what she needed: common faults, clear cures, diagrams of the inner valves. She had been told that Dr. Sato had once dismantled the PC-10 during a midnight storm and reassembled it with a superstition of care. She imagined him, flashlight in teeth, reading the very pages she now held.

Over time, the platinum coil oxidizes and degrades. Replace the coil if it shows signs of thinning, pitting, or uneven heating. Finding the correct settings requires a methodical approach

Adjust the mechanical weight stack located on the slider assembly. Creates long, gradual tapers with small tips.

| Feature | Detail | |---------|--------| | Pulling method | Vertical, single-cycle, gravity-assisted | | Heating | Nichrome filament (adjustable current) | | Glass compatibility | Borosilicate (1.0–1.5 mm OD, 0.5–1.0 mm ID) | | Pulling force | Adjustable weight + solenoid release | | Heat adjustment | Continuous dial (0–100) | | Timer | Not present – uses manual trigger + heat intensity | | Dimensions | ~200W × 300H × 200D mm | | Power | 100–240 V AC (external transformer) | The heating coil is warped or oxidized unevenly

Any your unit is currently displaying Share public link

Only replace fuses with the exact amperage and speed rating specified on the rear panel. 2. Hardware Anatomy and Control Interface