Press the to exit programming mode and return to the main time screen. Deleting a Specific Program Block

Stays OFF from 08h00 to 15h00 and during peak times. Ideal for homes with solar geyser setups.

While still holding the Clock button, press to adjust the current minutes. Release the Clock button. Your current time is now saved. Programming the ON/OFF Schedules

The KES timer allows you to configure up to 16 separate ON/OFF cycles. For optimum efficiency, program your geyser to turn on 1 to 2 hours before your typical shower or usage times, and program it to turn off immediately afterward. Programming Schedule 1 (ON Cycle)

is a specialized device designed to slash electricity bills by preventing your geyser from running during peak demand periods. Unlike standard digital timers, this unit focuses on "load control," specifically targeting the high-cost morning and evening peaks. Getting Started: Understanding the Indicator Lights

Ensure the Earth wire from the main board bypasses the timer entirely and connects directly to the geyser's earth terminal or the distribution board's earth bar. Interface Layout Overview

Hold the Override and Program buttons together to verify the Real Time Clock (RTC). The LED for Program 1 will flash, allowing you to set the hours, minutes, and day of the week.

If you need hot water immediately when the timer is off, press the Overload/Override button. Note that the controller may prevent manual heating specifically during designated peak demand times to protect the grid.

Press the button to set the exact hour you want the geyser to begin heating.

Press the button to select the time the geyser should turn off. Press the MIN button to select the precise cutoff minute. Additional Programs and Exiting