: Configure emergency alarms and "Display Reverse" for better visibility. Hardware Requirements
Even experienced programmers face issues. Here are solutions to frequent problems:
Windows XP, Windows 7, Windows 8, and Windows 10 (32-bit or 64-bit). Windows 11 users may need to run the software in "Compatibility Mode." Hyt Tc-580 Programming Software
Securely connect the 2-pin programming cable to the radio accessory jack. Plug the USB end into your PC. Turn the radio on and set the volume to roughly 50%.
| Specification | Details | |---|---| | | VHF: 136–174 MHz; UHF: 350–390 MHz, 400–470 MHz | | Channel Capacity | 256 channels (32 zones) | | Channel Spacing | 25 kHz (wide) / 12.5 kHz (narrow) | | Operating Voltage | 7.4V DC | | Battery Options | 1650mAh (standard), 1100mAh, 2000mAh | | Battery Life (5/5/90 duty cycle) | Up to 13 hours (2000mAh battery) | | RF Power Output | VHF: 5W/1W; UHF: 4W/1W | | Dimensions | 117mm × 53mm × 36mm | | Weight | Approx. 287g (with antenna and battery) | | Sensitivity | ≤ 0.25/0.28μV | | Receiver Audio Power Output | 1W | : Configure emergency alarms and "Display Reverse" for
You need the official HYT CPS designed specifically for the TC-580. This software runs on Windows operating systems.
Channel configuration is the most common task performed with the programming software. For each of the 256 channels, you can set the following parameters: Windows 11 users may need to run the
Open the Windows Device Manager and expand the "Ports (COM & LPT)" section. Note the COM port number assigned to your programming cable (e.g., COM3).
Now the real work begins:
Before connecting the radio, install the programming software. Next, install the drivers for the USB programming cable. It is crucial that the computer recognizes the USB cable in the Device Manager before trying to read the radio. 2. Connecting the Radio Plug the USB cable into the computer. Connect the two-pin jack into the side of the TC-580. Ensure the radio is powered on. 3. Reading the Radio Open the TC-580 Programming Software. Select the correct COM port in the settings menu.