To rule out a broken case button, unplug the PWR_SW cable. Gently touch a metal screwdriver tip to both Pin 6 and Pin 8 simultaneously for one second. If the system fans spin up, your motherboard works perfectly, and either your case button is broken or the wire was connected incorrectly.
Your reset switch or power switch might be shorting against an adjacent pin, or your motherboard stands are causing a short circuit behind the board. Ensure all front panel cables are cleanly separated.
If you have completed the wiring and your system does not behave as expected, review these common troubleshooting steps: The PC Will Not Turn On At All
Connects to the reboot/reset button on your case. foxconn n15235 motherboard front panel connectors
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
(Note: On some variations, Pin 9 is completely missing as a physical guide key, and Pin 10 is empty/NC). Pin-by-Pin Function Table Pin Number Signal Name Description Connected Component Hard Drive Activity LED (Positive) HDD LED Cable (Positive/Colored wire) Pin 3 Hard Drive Activity LED (Negative) HDD LED Cable (Negative/White or Black wire) Pin 5 Reset Switch (Ground/Negative) Reset Switch Cable Pin 7 Reset Switch (Signal/Positive) Reset Switch Cable Pin 9 No Connection (Empty space or blank pin) Pin 2 Power LED (Positive) Power LED Cable (Positive/Colored wire) Pin 4 Power LED (Negative) Power LED Cable (Negative/White or Black wire) Pin 6 Power Switch (Ground/Negative) Power Switch Cable Pin 8 Power Switch (Signal/Positive) Power Switch Cable Step-by-Step Cable Installation Guide
This light indicates whether the computer is awake, asleep, or turned off. To rule out a broken case button, unplug the PWR_SW cable
Look at the thin bundle of wires coming from the front of your computer case. You will find small, black plastic female connectors labeled: (or PW_SW) Reset SW (or RES_SW) HDD LED (or H.D.D. LED)
Find Pin 7 and Pin 9 (Row 2, positions 3 and 5). Connect the "Reset SW" connector here. Again, polarity does not matter.
To properly connect the front panel connectors on the Foxconn N15235 motherboard, users should refer to the motherboard manual or online documentation. The manual will provide detailed information on the location and function of each connector, as well as the correct pinout for each connector. Your reset switch or power switch might be
Set your multimeter to continuity mode. Touch the probes to pins 3 & 4 while pressing the power button on the case. You should hear a beep. If not, the case switch is broken.
Alternatively, if your Reset SW is a single 2‑pin connector, align it over pins 5 and 7.
Look at the of the motherboard, near the SATA ports and the CMOS battery.
