IP66 and IP67, utilizing a rugged 316 stainless steel housing.
Mount both units to rigid structures, such as heavy steel girders or reinforced concrete pillars. Avoid thin metal sheeting or handrails subject to vibration.
4 to 20 mA analog interface alongside digital HART® communication.
The receiver communicates its operational status via specific mA current levels sent to the control system:
ATEX, IECEx, FM, and CSA for hazardous Zone 1 and Zone 2 areas.
Verify that the gas reading on your controller matches the target concentration noted on the test film jacket within acceptable tolerances ( Remove the film and ensure the system returns to 4.0 mA. 7. Troubleshooting Common Manual Error Codes
If you need help with a specific part of the setup, let me know:
Physical obstacle in beam path; severe ice build-up; heavy dirt accumulation on windows.
Methane, ethane, propane, butane, ethylene, and propylene.
After achieving optimal alignment, you must establish a baseline or "Zero" point in clean air.
Are you using a or a voltmeter for configuration?
of operation, with weekly summaries available for up to 10 years. Interface Options: Users can utilize the Pulsar Interface Adapter (PIA) to connect a HART® handheld terminal or use a PC with Dräger PolySoft software for deep configuration and troubleshooting. Self-Monitoring:
Note: Always refer to the original Dräger Pulsar 7000 Series Instructions for Use for the most complete, up-to-date safety information and procedural details.
The Pulsar 7000 is built for "predictive maintenance" to minimize downtime. Data Logger:
The Drager Pulsar 7000 manual provides detailed instructions on operating the device. Here are the general steps:
