A Chase is a sequence of pre-saved scenes played back one after another to create motion and dynamic energy. Step-by-Step Chase Recording
This comprehensive guide will walk you through everything from unpacking your unit and understanding DMX cabling to programming complex scenes, chases, and activating manual control modes. 1. Unpacking and Hardware Overview
Sometimes, you want to take over without relying on pre-programmed sequences—such as highlighting a speaker at a podium or adjusting a spotlight on the fly.
Repeat steps 3 and 4 to add subsequent steps. You can add up to 240 steps into a single chase. disco 240 dmx controller manual
Simultaneously press and hold the and Bank Down buttons. Turn the power switch back on while holding these buttons.
The Disco 240 DMX Controller Go to product viewer dialog for this item.
If you have programmed your lights into a specific "look," you can recall it instantly. While in (EDIT/RUN LED off), press the RUN SCENE button followed by a P1 – P12 button. This recalls a pre-programmed snapshot. A Chase is a sequence of pre-saved scenes
The manual dedicates a section to the communication cable for a very important reason: signal integrity is key.
Hold down the button for roughly 2 seconds. The PROGRAM indicator on the display will flash. B. Creating Scenes Enter Program Mode . Select a Bank (01-30) using the Up/Down buttons.
Press and hold the button for approximately three seconds until the small LED indicator next to it begins to flash. This flashing light confirms the board is ready to record data. Phase 2: Designing and Saving a Scene Unpacking and Hardware Overview Sometimes, you want to
Repeat this process to build up to 8 unique scenes within your chosen bank. Phase 3: Building a Chase
This guide provides a general overview of the Disco 240 operation based on typical user manuals. Always refer to the specific documentation included with your controller, as variations may exist. If you have a , Share public link